Surfa Wood Rich NC Sanding Sealer Paint

Method of Application

Surface Cleaning:

• For Pre-Polished Wood: Remove all existing coatings by sanding or scraping
• For New Wood: Wooden surfaces to be sanded by using emery paper No.180 followed by 320. Clean the surface free of dust particles by wiping off.
• If necessary, remove dust and grease using a cloth soaked in Surfa D13 N.C thinner or equivalent.

Under Coat:  To fill minor pores, apply Surfa N.C Wood filler using a putty knife or muslin cloth and remove excess coating. Sand the coat after 1 hour with emery paper No.240 and wipe clean.

To Seal the surface: Thin Surfa N.C Sanding Sealer with 100 parts of Surfa D13 N.C thinner for padding or 150 parts for spray. Permit 1 hour interval between successive coats. Use emery paper 240/320 to scrub leftover coats. Apply minimum 2 coats for better sealing.

Top Coat: For Top coat, use one of the following products Surfa 1K Acrylic Clear Matt/glossy or Surfa NC Cabinet Clear or Surfa Wood Shield- Glossy (PU based).

Apply the products strictly as per following directions

• For Surfa 1K Acrylic Clear Matt on filled wood: Apply 3 coats of Matt. For Surfa 1K Acrylic Clear Glossy use 2 coats of Matt and 2 coats of Glossy. To dilute Surfa 1K Acrylic Clear use 40-50 parts of Surfa NC Thinner SP 58.
• For Surfa N C Cabinet Clear Glossy/Matt: Thin with 50 parts of Surfa N C Thinner SP50. Apply minimum 2 coats by spray for better result. Further coats can be applied, if more gloss is required. Allow minimum 2 hours interval between successive coats. Use emery paper No 400/600 between coats.
• For Surfa Wood Shield Interior Glossy (PU Based): Thin with for brushing add 10% of Thinner  14 or Enamel Thinner 600 and mix well. For spraying add 20% of Thinner 14 or Enamel Thinner 600 and mix well. Apply 2 coats of thinned Wood Shield Interior Glossy by brush or spray allowing 12 hours drying time between coats.