Easy Wash Premium Interior Emulsion Paint

Surface preparation

Clean the surface thoroughly, sand the surface with Emery Paper 180 rendering it free from previous paint coatings, flaking, loose particles, dust, dirt, oil, grease, grime etc. and wipe it clean.

Directions for use

• On well dried and cleaned surface, apply a coat of Surfa Water Based Acrylic Cement Primer and allow drying for 6-8 hours.
• Rectify the undulations and smoothen the surface by applying thin coats of Surfa Acrylic Wall Putty allowing it to dry for 6-8 hours.
• Sand the surface with Emery Paper 320 and wipe it clean.
• Do not apply easy wash- premium emulsion directly over putty as that would lead to patchy appearance.
• On primed and puttied surface, apply 2 or 3 coats of EASY WASH Premium Emulsion thinned with 450/500ml of clean potable water for 1 liter of paint. Leave a gap of 3-4 hours between coats.
• To remove dirt, stain, from painted walls wash with water / mild soap solution (avoid detergent), after one month of painting.
• For base white, tinting if required must be done before thinning.
• Do not over thin.
• Stir well and strain before use.
• Contains no added lead, mercury or chromium compounds. Stir well and strain before use.
• (Information in this leaflet is given in good faith but without warranty).

Safety, health & environmental solution

• Keep out of reach of children and away from food, drink and animal feed.
• Apply in well ventilated areas. Do not breathe vapour or spray.
• Do not pour leftover paint down drains or in water courses.
• Contain spillage using sand or earth.
• Store container in an upright position with lid tightly closed, in a cool and dry place.